This file contains additional information, probably added from the digital camera or scanner used to create or digitize it.
If the file has been modified from its original state, some details may not fully reflect the modified file.
It's the goods lift again - COP Inspection switch
February 24, 2009
I'm back at the goods lift installed by Express Lifts somewhere in the 1,980s.
Inside the Car Operating Panel (COP) there are three toggle switches:
Left: ISOLATE / NORMAL
Middle: INSPECTION / NORMAL
Right: UP / DOWN
These switches enable you to stop normal operation and move the lift up and down using Inspection mode (these switches in the COP are apparently unique to older Express Lifts and may not be found on other manufacturers, except on the lift car roof)
When switching to Inspection mode, if the lift car is within a door zone - both sets of doors open (car and the landing you are at). When switching back, see the floor indicator gets mixed up! It seems to sort itself out after visiting the highest and lowest floors.